Sweep & inspection
Caps & crowns
Flue relining
Masonry repair
Gas fireplace serviceLevel 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Fast, Reliable Chimney Cap & Crown Across Kensington
If you live in Kensington and your chimney cap looks like it’s been through a few too many winters, you’re not imagining it. Most of the caps we see on Kensington roofs are galvanised steel that has pitted and rusted through at the seams, and the mortar crown above is usually hairline-cracked from years of freeze-thaw. We handle cap replacement, crown repair, and multi-flue caps on the rowhouses and apartment buildings along Church Ave, Ocean Parkway, and the side streets between them. Our technicians have up to 9 years of experience, and we know how these old masonry stacks are built. Call (833) 554-1032 to book a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Why Kensington Homeowners Call Chimney Sweep Borough Park for Chimney Cap & Crown
Kensington is a dense, old neighborhood, and the chimneys here have their own logic. Most of these stacks were built for coal, then converted to gas or oil furnaces. The flues were never relined to match the new appliance, and the caps and crowns on top have taken decades of weather. We know that because we work on these buildings, not because we read it somewhere.
Our reputation in Kensington comes from doing the diagnostic work properly. We run a formal chimney inspection before recommending anything, and we show you the photos. What that means in practice: we point a camera at the crown, the flashing, and the flue, and you look at the same images we do. If the crown can be coated and doesn’t need a rebuild, we tell you.
Response time to Kensington is straightforward. We’re working in the neighborhood and the surrounding blocks regularly, so booking a cap or crown visit here doesn’t mean waiting weeks. We answer 24/7 and dispatch from 7am to 7pm, Sunday through Friday.
What builds trust locally is the shared-stack knowledge. In Kensington’s attached rowhouses, one chimney mass routinely serves two addresses. A rusted cap or a spalled crown on one side of the party-wall stack lets water and flue gas migrate into the neighbor’s flue. We scope the whole stack, not just your flue. That’s a different approach than a generalist who caps one pipe and leaves.
Styles & brands we work with
- Sweep & inspection
- Caps & crowns
- Flue relining
- Masonry repair
- Gas fireplace service
Our Chimney Cap & Crown Services in Kensington
We cover the full range of cap and crown work, from single-flue replacement to full shared-stack scoping. All of it is handled by the same crew, start to finish. Here’s what each service involves.
Cap Replacement in Kensington
Most Kensington caps we replace are galvanised steel that has rusted through at the seams. That rust doesn’t just look bad; it stains the brick face below and lets water into the flue. We replace with stainless caps sized to the appliance actually venting the flue, and we photograph the old one before we pull it so you can see what failed. A properly fitted stainless cap is the single most effective thing you can do to stop water intrusion on a Kensington chimney.

Crown Repair in Kensington
The mortar crown is the concrete cap at the very top of the chimney, and in Kensington’s freeze-thaw winters it takes a beating. Water gets into a hairline crack, freezes, expands, and widens it. We repair crowns by removing the failed mortar, rebuilding the slope so water sheds properly, and sealing the joint where the crown meets the flue. If the crown is too far gone to repair, we rebuild it. We’ll tell you which one you need before we start.

Crown Coating in Kensington
For crowns that are cracked but structurally sound, a crown coating can extend the life of the masonry without a full rebuild. We use trade-grade coating materials that flex with the masonry instead of cracking away from it. This is the right call when the crown has surface cracks but the underlying mortar is still holding. It’s also cheaper than a rebuild, and we’ll say so when it’s the right option. You can read more about the full scope on our chimney cap & crown service page.

Multi-Flue Caps in Kensington
Kensington’s older apartment buildings and shared rowhouse stacks often have more than one flue running up the same chimney mass. A multi-flue cap covers the whole stack with one stainless unit, sized to the number of flues and the appliances venting them. This is common on the 1920s and 1940s apartment buildings along Ocean Parkway. A single-flue cap on a multi-flue stack leaves the other flues exposed, so we size the cap to the whole crown.
Trusted Brands We Service in Kensington
We work with a fixed set of trade-grade brands because they hold up in this climate. For caps, we install Olympia Chimney and Gelco stainless units, sized to the flue and the appliance. For crown and masonry work, we use Famco and Copperfield materials that are specified by certified chimney professionals. These are the brands we trust on Kensington roofs, and we don’t substitute. We don’t stock parts locally; we order what the job needs and schedule the install around that. What that means for you is a cap that fits the flue properly, not whatever was on the shelf. Trade-grade materials, properly installed, is the whole idea. If you want to know exactly which brand we’d use on your chimney, ask when you call.
Common Chimney Cap & Crown Problems We See in Kensington Homes
The failure modes here are consistent. These are the four we see most often on Kensington chimneys.
- Galvanised caps pitting and rusting through at the seams. This is the most common call we get in Kensington. The rust sends stained runoff down the brick face and eventually lets water into the flue. A stainless replacement ends the cycle.
- Mortar crowns cracking through freeze-thaw cycles and spalling. New York’s winters crack aging mortar crowns on Kensington’s old masonry stacks, and summer humidity promotes spalling. Once the crown spalls, water has a direct path into the clay flue liner below.
- Original flashing pulling away at the chimney-roof joint. On old shared stacks, the flashing at the roof line is often original and has pulled away from the masonry. Moisture then tracks into a neighbor’s flue through the common chimney mass. This is a shared-stack problem, and it needs a shared-stack inspection.
- Condensate damage from high-efficiency gas furnaces. Modern high-efficiency gas furnaces produce condensate that can degrade old clay liners over the heating season. On a coal-era flue that was never relined, this shows up as flaking and deterioration at the top of the liner, right under the crown.
See the difference
Before
After
Before
After
Before
AfterPricing for Chimney Cap & Crown in Kensington, NY
Here’s what cap and crown work typically runs in Kensington. A typical single-flue stainless cap installation in Kensington runs $275 – $550, depending on flue size and cap style. A multi-flue cap for a shared rowhouse stack runs $550 – $1,100. Crown repair, including removing failed mortar and rebuilding the slope, runs $400 – $900. A full crown rebuild on a deteriorated crown runs $800 – $1,600. Crown coating for a cracked but structurally sound crown runs $350 – $650.
What moves the price is access and stack complexity. A shared party-wall stack with multiple flues takes longer to scope and cap than a single-flue chimney. Height and roof pitch also matter. The written estimate sets the final price, and the estimate is free. Nothing gets recommended without camera evidence you can see for yourself, and we’ll tell you plainly when work can safely wait.
| Service | Typical Kensington Range |
|---|---|
| Single-flue stainless cap installation | $275 – $550 |
| Multi-flue cap (shared stack) | $550 – $1,100 |
| Crown repair | $400 – $900 |
| Crown rebuild | $800 – $1,600 |
| Crown coating | $350 – $650 |
We Also Serve Cities Near Kensington
We work across the neighborhoods around Kensington, including Flatbush, Borough Park, Midwood, and Sunset Park. The housing stock is similar, the chimneys are similar, and the shared-stack problem shows up across all of them. If you’re in any of these areas and need cap or crown work, the process is the same. We scope the whole stack, photograph what we find, and give you a written estimate before any work starts. You can see our full coverage area on the Kensington page.
Serving Kensington, NY – Our Local Coverage Area
We serve Kensington and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Chimney Cap & Crown in Kensington
No. On a shared Kensington stack, capping only your flue leaves the neighbor’s flue exposed, and the common chimney mass still lets water and flue gas migrate between the two. We scope the whole shared stack and size the cap to cover all the flues on that mass. That’s the only way to stop the cross-migration problem. Call (833) 554-1032 for a free estimate on your shared stack.
Because galvanised steel in this climate pits and rusts through at the seams within a few seasons. Kensington’s freeze-thaw winters and summer humidity accelerate the corrosion, and the rust then stains the brick face below. A stainless cap solves it. The upgrade pays for itself compared to replacing a galvanised cap every few years. Call (833) 554-1032 to schedule a cap replacement.
Once a year is the right interval for Kensington’s old masonry stacks. Freeze-thaw cycles crack mortar crowns, and a hairline crack that gets caught early can be coated instead of rebuilt. Left alone, that crack opens a path for water into the clay flue liner. An annual inspection is far cheaper than a rebuild. Call (833) 554-1032 for a free estimate.
It depends on how deep the cracks go. Surface cracking on a structurally sound crown can be coated. Cracks that go through the mortar, or a crown that has spalled badly, need a rebuild. We photograph the crown from the roof and show you the images before recommending either. You see what we see. Call (833) 554-1032 for a free estimate.
Sometimes, but not always. A cap that’s too small or the wrong style for the flue can restrict draft, and replacing it with a properly sized stainless cap can help. But draft problems in Kensington’s older apartment buildings often trace back to a flue that’s the wrong size for the appliance or a liner that’s deteriorated. A formal inspection tells you which one you have. Call (833) 554-1032 for a free estimate.
Book Your Cap or Crown Estimate in Kensington
Cap and crown work is the cheapest insurance a Kensington chimney has. A rusted cap or a cracked crown lets water into a flue that was never designed for today’s appliances, and the repair only gets more expensive the longer it waits. We scope the whole stack, photograph what we find, and give you a written estimate before any work starts. The estimate is free, and the written estimate sets the final price. Call (833) 554-1032. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday.
Written by the team at Chimney Sweep Borough Park.